McQuay PDAE Instructions d'exploitation Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 38
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
IM 950-1 / Page 9 of 38
Condensate Drain Kit Installation
Figure 10 illustrates the installation of the indoor
drain kit. The indoor drain kit must be installed before
placing the cabinet/wall sleeve into the opening.
Assembly of the external drain kit should be completed
after the cabinet/wall sleeve has been installed.
Indoor Drain Kit Installation
1. Locate the drain so that it will be on the room side
of the wall when the wall sleeve is installed.
2. Drill a 1/2" diameter hole in the base of the wall
sleeve for the drain.
Alternate 6" Long, 1/2" O.D.
Straight Copper Tube
External Drain Kit
Figure 10. Indoor Drain Kit
Cover
Plate
Tube
Gasket
Screws
1/2"
(13mm) O.D.
Cabinet Bottom
Neoprene Sponge Gasket
Steel Mounting Plate
Indoor Drain Detail
Contractor To Drill Three (3) Holes To Accept
Drain Kit
3. Drill two (2)
5/32" pilot holes for the mounting
screws. These holes can be located using the drain
kit as a pattern.
4. Assemble the drain kit as shown in Figure 10 and
securely fasten it to the wall sleeve with the
screws provided. Use either the 90
o
elbow or 6"
straight tting as required.
5. Install the cabinet/wall sleeve as described on
pages 10-11.
Note: When using the external drain kit, the sleeve
must be ush or beyond the outside nished wall (do
not recess).
External Drain Kit Installation
1. Assemble the drain kit as shown in Figure 11.
2. Choose the side of the cabinet/wall sleeve to which
the drain kit is to be installed.
3. There are drain holes and pilot holes provided in
the wall sleeve from factory. Place the drain kit
against the chosen drain hole and fasten securely
with screws provided. Use either the 90
o
elbow or
6" straight tting as required.
4. Cover the unused drain hole with the block off
plate and gasket supplied with the drain kit.
Indoor Drain Kit
Room Side
Neoprene
Sponge
Gasket
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Commentaires sur ces manuels

Pas de commentaire